Heels Heel represents a certain thickness (4 to 7 mm) layer of rubber or other material (e.g., polyurethane).
The material should not be too soft to Heel is not squeezed while walking, especially if the main hollow heel. And it is not too hard, because no damping on the pavement, such Heel quickly wears out.
The first step is to remove the remains of the old taps with a screwdriver blade. If the heel is hollow, void fill better. You can cut the old taps and turning the knife attachment, reinsert. Can be filled, for example, wooden plugs. Plugs should include tight, but do not overdo it with the thickness - or heel can break.
Take the selected material, put it on him, and to outline the heel with a small allowance - 2 - 4 mm.
With a sharp knife carefully cut the workpiece. Zachistte side, which will be printed cloth attached to the heel, emery cloth. Sand and end of the heel.
Grease the end of the heel and the stripped side adhesive taps and soak for about 20 minutes. Adhesives suitable brands "Uranus", "Octopus", "Kvintol" can be purchased in the departments of household goods.
After the lapse of time required to attach taps its intended location and press. Now take a pre-cooked cloves diameter of 1.5-2.0 mm and a length of 18-20 mm and hammer them on the perimeter. Cap must sink flush Heel good cuddle.
Be careful not to touch the varnished surface of the heel, cut the side of the heels and a rasp or a file completely smooth out the edge.