For the manufacture of knitted bracelet you will need:
1. Basis for the bracelet.
2. Remains of yarn.
3. The spokes or the hook.
4. Needle.
For the basics, you can take an old plastic bracelet. But if there is none, can be made the basis of their own. Of what? The material should be moisture resistant. You can cut the workpiece from a plastic napkin under the cutlery or plastic bottles or cans. There are many solutions. After a suitable strip is cut, it must be twisted together into a "donut" and fasten ends stepplerom. Then the workpiece need to sheathe dense tissue as follows: Cut a rectangle of fabric width equal to the width of the bracelet, multiplied by two, and a length equal to the circumference of the bracelet. Sew the beginning and end of the strip and put it on the base, edge stitching on the inside of the bracelet.
Thus, the basis we have. Now we need to make the harness bracelet. To do this, how to knit more tightly striped. To calculate the desired width of the strip, measure the width of the bracelet and multiply it by two. But a little longer knit to end up with knitted fabric strips to pull on the bracelet.
Cloth strips decorate with braids knitting Aran, knobs, or a pattern of right and wrong loops. Avoid openwork knit, since through it will look through basis. As the web reaches the desired length (equal to the circumference of base), close the loop. Make sure that the pattern came to an end so that when connecting the start and end of the strip, he looked harmoniously.
Close the strip into a circle and sew the beginning and the end. Slip ring from the substrate strip and stretch so that one side edge hinge concerned on the inner portion of the base edge strip of the other loops. Make a seam connecting loop.
Your bracelet is ready! You can decorate it with beads, sequins or beads.
Wear with pleasure!