How to sew the eastern zone

 For the manufacture of belts need lining fabric (crinoline), dense fabric for the base (jeans, furniture fabric), glue - for mounting and elegant - for the outside. Fasteners needed for hook and loop or adhesive tape. To sit tight and times are not cool during the dance, you have to stock up silicone tape. Prepare as rhinestones, fringe, beads, sequins - in accordance with your plan decoration belt.

Since the belt should be wide enough to sit tight and well on the figure, you will need a pattern. You can take as a basis the pattern straight skirts and cut fragment corresponding to the band belt.

Self pattern is as follows: girth measured at the upper belt line, the girth on the bottom line, the difference between these values ​​will be the total depth of the tucks. There are only six: two side, two rear and two front. To calculate the depth of the side tuck multiply this difference at 0, 5 and divide by two; to calculate back tucks multiply the difference by 0, 3, then divide into two; for front tucks - multiply the difference by 0, 2 and divide by two.

On a paper strip width corresponding to the width of the belt, and the length - the circumference of the bottom edge of the belt, mark the half, it will be in front and back. Before you set aside at the center of the left and right by 12 cm, on the back - 10 cm, it will be the axis of the front and back darts. Axis side tuck - in the center of the strip. The second side tuck delayed by halves on the left and right edges of the strip.

Cut a strip along the axes of darts, align them how the pins, put the resulting strip on a piece of paper, turn, add to the fastener 6 cm at each end (in this case the fastener is located on the side). Now you can draw on the basis of any form of belts: with carved asymmetric edge in the form of "The Seagull" or flat round, then cut out the pattern.

Transfer the pattern on heavy backing fabric and cut without seam allowance. Place the cut parts on the main thick cloth, circle with chalk, glue the parts together using adhesive tape, then cut without seam allowance. For stiffness prostrochite bonded parts along sections and randomly within a simple line.

Attach the resulting rigid substrate crinoline down to the top of the facing fabric circle circuit without seam allowance on the side sections to add hem to 5 cm. Cleave the pins, baste close to the cutoff defer.

Trim the excess fabric lining without seam allowances, allowances bend on the wrong side and hem hands. Treat sections bias binding to match the lining tissue (fringe along the bottom edge sew belt inside out, the rigid substrate).

Then decorate belt obsheyte wrong side of the lining fabric, sew the hook and loop fasteners. To secure the belt in Figure sew along the top edge from the inside silicone tape that sticks to the skin. If the belt should lie on the skirt, between the skirt and the belt can sew pieces of adhesive tape.