Pick up the paper with the chosen pattern and accurate movements draw around it with chalk. Encircled side to attach the paper to the product on which you want to portray your masterpiece. Using a pencil or pen make drawing a stroke. When you remove a leaf, it will be translated on the product image.
Prepare rhinestones required colors and sizes. For the first time it is best to choose the larger stones, and preferably of the same diameter. Heat the low-power consumer soldering iron, make sure that the power of the device was really small and does not exceed 50 watts.
Apply solder to every pebble on the five or ten seconds, but no longer. And placed them in turn to their designated places in the figure. Note: touch the soldering iron to the surface of the product is impossible, as it can burn.
Do the procedure slowly, putting one lens, try to stick once all part of the picture is not necessary. Once you paste all the crystals, do not rush to immediately start using the thing, because the resulting figure must be more secure.
To do this, take an ordinary iron and heat it to medium heat. On top draw pictures directly on the product, the bed fine cloth, put on her iron and hold it for about twenty seconds. Then check whether all carefully stuck. If, for any part of the figure is not stuck to the end, then repeat the process with an iron.
Note that attaching in this manner can not all crystals, and only fusible. They stick well, due to heating temperature.